Hilti GX-IE Manual De Instrucciones página 9

Instructions for handling the propellant gas
▶ Observe the safety instructions printed on the gas can and in the accompanying information.
▶ The gas is highly flammable. Keep the gas can away from open flames and other sources of ignition.
▶ Escaping gas is harmful to the lungs, skin and eyes and can cause cold injuries and burns. Keep your
face and eyes away from the metering valve and the gas can compartment for up to approximately 10
seconds after removing the gas can.
▶ Never attempt to remove or manually operate the metering valve of a gas can that has been prepared
for use or is in use. Considerable quantities of pressurized liquefied gas could escape, endangering you
and other persons.
▶ If a person has inhaled gas, take the person into the open air or into a well-ventilated area and place the
person in a comfortable position. Consult a physician if necessary.
▶ Call a doctor if the person is unconscious. Bring the person into a well-ventilated area and place the
person in the stable recovery position (i.e. lying on the side). If the person is not breathing, administer
artificial respiration and, if necessary, supply oxygen.
▶ After eye contact with gas, rinse the open eyes thoroughly under running water for several minutes.
▶ After skin contact with gas, wash the contact area carefully with soap and warm water. Subsequently
apply a skin cream.
3 Description
3.1 Product overview
3.2 Intended use
The product described is a gas-actuated fastening tool. It is for driving suitable fasteners into concrete and
other materials suitable for use of the direct fastening technique.
The fastening tool, gas can, battery and fasteners form a technical unit. This means that trouble-free
fastening with this fastening tool can be ensured only when it is used together with the fasteners, gas cans
and batteries specially manufactured for it by Hilti. The fastening and application recommendations made
by Hilti apply only when these conditions are observed.
The fastening tool is for hand-held use only.
▶ Use only the Hilti B12/2.6 and respectively the B 12­30 Li ion battery for this product.
▶ Use only Hilti battery chargers of the C 4/12-50 series for charging these batteries.
*2208858*
1
2208858
Fastener guide
@
Fastener guide release slider
;
Belt hook
=
Safety trigger
%
Cooling air slots
&
Gas can compartment
(
Battery release button
)
Battery state of charge indicator
+
Gas can status indicator button
§
Gas can status indicator
/
Battery
:
English 5