Installation Informations; Battery Installation; Battery Connection - Lavorwash QUICK 36E Manual

5.2.

BATTERY INSTALLATION

The battery compartment is placed in the solution
tank ( Photo 14 ) and to access it is necessary to re-
move the recovery tank; to remove the recovery tank,
detatch the suction hose from its siege ( Photo 4 - B )
and lift the tank by pulling it up as shown in Photo 13.
Place the battery in the battery compartment (Photo
14) checking that it is in perfect conditions.

5.2.1. BATTERY CONNECTION

• Attach the battery wiring to the battery, connect-
ing the terminals only on the poles marked with the
same symbol (red wiring "+", black wiring "-") as
shown in the connection diagram in Photo 15.
A battery short-circuit may cause an explosion!
After checking that all the controls on the panel are in
position "0" or at rest, connect the battery connector
to the machine connector ( Photo 16 - B ).
Photo 16 shows the correct battery connection.
• Close the battery compartment replacing the re-
covery tank, making sure not to crush any wire.
A
D
C
Photo 16

5. INSTALLATION INFORMATIONS

B
37
Photo 13
Photo 14
Photo 15
A) 12V Battery with cabling
B) Battery connector
C) Suction motor thermal breaker
D) Traction motor thermal breaker