Checks Before Installation; How To Remove Panels - Hoshizaki KM-470AJE-R452 Manual De Instrucciones

ENGLISH
B. Checks Before Installation
• Visually inspect the exterior of the shipping container and immediately report any damage to
the carrier. Upon opening the container, any concealed damage should also be immediately
reported to the carrier.
• Remove the shipping carton, tape, and packing material. If any are left in the appliance, it
will not work properly.
• See the nameplate on the left panel, and check that your voltage supplied corresponds with
the voltage specified on the nameplate.
• Remove the panels to prevent damage when installing the appliance. See "II.C. How to
Remove Panels."
• Remove the package containing the accessories.
• Remove the protective plastic film from the panels. If the appliance is exposed to the sun or
to heat, remove the film after the appliance cools.
• Check that the refrigerant lines do not rub or touch lines or other surfaces, and that the fan
blade (if applicable) turns freely.
• Check that the compressor is snug on all mounting pads.
• The icemaker can be installed on a storage bin 30" wide or wider. Hoshizaki Ice Storage
Bins, Model B-210SA is recommended. For further options, contact your local Hoshizaki
distributor.
Model Number
KM-470AJE-R452
For further options, contact your local Hoshizaki distributor.
C. How to Remove Panels
See Fig. 1
• Front Panel: Remove the screw. Lift up and
pull towards you.
• Top Panel: Lift up at front slightly, push
rearward and lift off.
• Right Side Panel: Remove the screw. Slide
forward slightly and lift off.
• Insulation Panel: Lift up slightly, and pull
towards you.
Bin Width Recommended Hoshizaki Ice Storage Bin
30" or Wider B-210SA
7
Insulation
Panel
Front
Panel
Fig. 1
Top Panel
Side Panel (R)