Filtering System; Frost Protection - cecotec BOLERO AGUAZERO 8000 FULL BUILT-IN Manual De Instrucciones

ENGLISH
- Before cleaning or doing any maintenance work, always remove the plug from the socket.
- Do not use abrasive cleaner agents.
Warning
- To avoid water entering the door gasket and the electric components, do not use any type
of spray cleaning agent to clean the dishwashing exterior.
- Never use abrasive cleaning agents or scouring pads in the exterior surfaces, as they can
scratch the finish. Some paper towels can also scratch or leave stains in the surface.

Filtering system

The filtering system in the base of the interior of the dishwasher retains coarse remains
-
from the wash cycle, including foreign objects such as toothpicks.
Coarse remains can block the filters.
-
Regularly check the condition of the filters, carefully remove foreign objects and clean the
-
filter system parts with water if necessary.
Follow these steps to clean the filter.
-
1. Hold the coarse filter and turn it counterclockwise to unlock it. Lift the filter upwards and
remove it from the dishwasher. Fig. 36
2. The fine filter can be removed from the lower part of the filtering set. The coarse filter
can be separated from the main filter by slightly pressing the tabs on the upper part and
pulling it. Fig. 37
Coarse filter
1.
Main filter
2.
Fine filter
3.
3. The biggest food remains can be cleaned by placing the filter under running water. For a
more complete cleaning, use a soft cleaning brush. Fig. 38
4. Reassemble the filters in the reverse order of disassembly, place the filter insert again and
turn it clockwise until you reach the locking arrow. Fig. 39
Warning
Do not press the filters too much. Place the filters again in a safe manner, otherwise large
-
remains may enter the system and cause a blockage.
Never use the dishwasher without the filters installed. Incorrect substitution of the filter
-
may reduce the performance level of the device and damage the tableware and utensils.
Spray arms
The arms accumulate chemical products so it is necessary to clean the spray arms
-
regularly, as the chemicals in the hard water clog the holes and bearings.
To clean the spray arms, follow these instructions:
-
1. To remove the upper spray arm, hold the nut and turn the arm counterclockwise. Fig. 40
2. To remove the lower spray arm, pull the spray arm upwards. Fig. 41
3. Clean the arms with soap and cold water and use a soft brush to clean the gaps. Fig. 42
90

Frost protection

Take frost protection measures in the dishwasher in winter. After every washing cycle,
-
follow these steps:
1. Turn off the electrical power to the dishwasher from the power supply.
2. Turn off the water supply and disconnect the water supply hose from the water valve.
3. Empty the water from the supply hose and from the water valve. (Use a pot to pick up the
water)
4. Connect the water supply hose again to the water valve.
5. Remove the filter from the bottom of the dishwasher and use a sponge to absorb the water
on the drain.
After every wash
After every wash, close the device water supply and leave the door slightly open for some
minutes so moisture and odours are not trapped in the interior.
When not in use for a long time
We recommend running a washing cycle without any load and, next, disconnect the plug
-
from the mains supply, close the water supply and leave the door slightly open.
This will help preserve the door gaskets for more time and will prevent odours forming
-
inside the device.
Transporting the device
If you want to move the device, try to do so in an upright position.
-
If it is absolutely necessary, you can place it backwards.
-
Gaskets
One of the factors that cause odours to form in the dishwasher is food trapped in the
-
gaskets.
Regular cleaning with a damp sponge will prevent this from happening.
-
ENGLISH
91
AGUAZERO 8000 FULL BUILT-IN