Tabla de contenido
Idiomas disponibles
Idiomas disponibles
DD40P
There a several orientation markings on the machine.
The base plate has markings on the top, front and
bottom side:
- Contact edge of the accessory guide fences (A)
- Drill bit center (B)
- Machine center (C)
The markings on the left and right of the side surfaces
correspond to the drill bit center.
The arrows on the front of the base plate show the
direction of rotation of the drill bits.
Likewise, vertical drilling with the machine is possible
by folding the swiveling guide fence (1). The swiveling
guide fence can then be used as an additional
support.
There are three markings on the swiveling guide
fence. The center marking corresponds to the
machine center. The markings on the left and right
correspond to the corresponding drill bit center.
Ensure that the contact surfaces of machine and
workpiece are aligned precisely with each other.
Use the following procedure to use the machine
for drilling:
1.
Clamp the workpiece or secure it against
moving.
Use the anti-slip mats provided for this
➢
purpose.
2.
Position the machine horizontally or vertically on
the workpiece, as required.
3.
Using the resilient stop pins or the accessories
described below, bring the machine in contact
with the outer edges of the workpiece.
Ensure that the contact surfaces of
➢
machine and workpiece are precisely
aligned with each other.
4.
Switch on the machine.
5.
Push the motor unit forward until it hits the stop.
6.
Pull back the motor housing and switch off the
machine.
✓
Drilling was performed.
01/2022
Fig. 12: Markings on the machine
Fig. 13: Preparing the machine for vertical drilling
Fig. 14: Drilling with the machine
17
Tabla de contenido
