Drilling With Accessories; Working With Special Accessories - Mafell DD40P Instrucciones De Funcionamiento Y Seguridad

5.4 Drilling with accessories

5.4.1 Drilling with ancillary guide fence set
The ancillary guide fences permit different edge distances.
Edge distances:
- A = 32 mm [1.26 in] / for hole rows
- B = 43 mm [1.69 in] / as repositioning guide fence
- C = 32 mm [1.26 in] / for miters
- D = 7.5 mm [0.31 in] / as parallel guide fence for
batten processing
The ancillary guide fences can be plugged into the
guide fence surfaces of the base plate.

5.5 Working with special accessories

Various special accessories are available for the machine. An overview can be found in chapter 8 Optional
accessories.
Some utilization methods are explained below.
5.5.1 Drilling with dowel gage
Use the following procedure for drilling
horizontally with the dowel gage:
1. Place the dowel gage flush with the face of the
workpiece and draw a marking on the left and
the right.
2. Position the dowel gage at the markings and
clamp it tight.
18
Fig. 15: Ancillary guide fences
Fig. 16: Plug-in locations for ancillary guide fences
Fig. 17: Drawing the position for the dowel gage
DD40P
01/2022