Residual Risks; Troubleshooting - Royal Catering RC-711 MB Manual De Usuario E Instrucciones De Funcionamiento

Warning
After performing all the operations necessary to restore the proper "sealing" of the gasket on the inside
glass of the door, check its tightness by running the oven: for at least 30 minutes, with a 100%
humidification cycle and with a cooking chamber temperature of 110°C. During oven operation no steam
must escape from the door.

4.6 Residual risks

Do not use the door handle to move the appliance: this may deform the door frame.
The appliance is fitted with electrical parts: it must never be washed with a water or steam spray.
The appliance is electrically connected: disconnect the power supply before performing any type
of maintenance.
To avoid incorrect connections of the appliance, the relevant electrical/water connections are
marked on the appliance by suitable identification plates.
Only for wheeled models
After installing the oven, ensure the tray trolley can be handled with ease, on smooth floors and
with no hindrance to insertion and extraction operations: the trolley is mounted on wheels, any
collision may cause the hot cooking food and/or liquids to spill and may even cause it to tip over.

5. TROUBLESHOOTING

Type of fault
Control panel warning
lights totally off
(The oven does not work)
Cooking cycle set: the oven
does not work
Automatic humidifier
active: no humidity/steam
production in the cooking
chamber
Closed door: steam escapes
through the gasket
The oven does not cook
evenly
Lamp (LED) in the cooking
chamber does not work
The thermal safety device is
activated continuously
(MF 1664 BM – MF 2011 BM)
Cause of the fault
- Non-compliant connection
power mains
- No mains voltage
- Safety thermal device triggered
- Door open or ajar
- Door sensor damaged
- Non-compliant water mains connection
- Closed stopcock
- Obstructed water inlet filter
- Damaged water inlet solenoid valve
- Non-compliant gasket assembly
- Damaged gasket
- Handle "nose" adjusted incorrectly
- One of the motors is down or operates
at low speed
- The motors do not reverse direction
- Resistor not powered or damaged
- Lamp (LED) damaged
- Damaged device
- Control thermostat damaged
Corrective action
to the
- Check the connection to the mains
- Restore the power supply voltage
- Restore the safety thermal device
- Close the door properly
- Contact a skilled technician
- Check the connection to the water
mains
- Check the cock
- Clean the filter
- Contact a skilled technician
- Check gasket assembly
- Contact a skilled technician
- Contact a skilled technician
- Contact a skilled technician
- Contact a skilled technician
- Contact a skilled technician
- Replace the lamp (LED)
- Contact a skilled technician
- Contact a skilled technician
10