Service And Maintenance; Chain Cutters; Storage - Mafell LS103Ec Instrucciones De Funcionamiento Y Seguridad

LS103Ec
Use the following procedure to produce a
recess:
1. Define the distance required for the recess.
2. Attach an appropriately sized wooden slat at
the boreholes on the transverse guide fence.
3. Position the machine on the workpiece and
mortise the recess.
Recess produced.
✓
6

Service and maintenance

MAFELL machines are of a low-maintenance design.
The installed ball bearings are lubricated for life. After a longer period of operation, MAFELL recommends that
the machine be handed over to an authorized MAFELL service workshop for inspection.

6.1 Chain cutters

After two hours of operation, the cutting chain should be cleaned and lubricated in a bath with thin-bodied oil.
This requires the cutting chain to be removed. For this, see the information in chapter 4.3 Mounting the cutting
chain assembly.
Replace a blunt cutting chain or have a blunt cutting chain sharpened in a MAFELL
Customer Service workshop.

6.2 Storage

Clean the machine thoroughly if you will not use it for quite some time. Spray bare metal parts with a rust
inhibitor.
02/2022
Fig. 16: Mortising a recess
17