Inlet Filter - Qilive Q.6806 Manual De Instrucciones

5.2. CLEANING AND REPLACING THE FILTERS
EN

5.2.1. INLET FILTER

The inlet filter is located behind the dust bag. Release the front cover lock (2) to open the front
cover (3) and remove the dust bag.
Fig. 12
Fig. 13
If the filter shows signs of wear and tear it must be replaced; Open the frame and remove
the filter from the frame. Replace with a new filter. Contact customer services for support.
5.2.2. CLEANING AND REPLACING THE OUTLET FILTER
To avoid the filter getting clogged, never use the vacuum cleaner without the filter.
The outlet filter is located under the air outlet cover (11). It cleans the exhaust air of the vacuum
cleaner.
Take out the air inlet filter frame by pulling it upwards
(Fig 12).
Clean the inlet filter with warm water and allow to dry
thoroughly before placing back into the unit (Fig 13).
Remove the air outlet cover (11) gently by pulling it from the
casing.
Fig. 14
Remove the filter from the vacuum cleaner (Fig 14).
Carefully shake off foreign objects or use a soft brush for
initial cleaning.
Wash the filter carefully in clean water without using any
cleaning agents. Leave the filter to dry.
Reinsert the filter after it is completely dry (Fig 15).
Fig. 15
12