Preparation For Wiring; Wiring. Pgs - Craftmade Cole Guia De Instalacion

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

5. Preparation for Wiring.

Lift motor housing to mounting plate and then hang
motor housing on j-hook on underside of mounting
plate. (Use one of the non-slotted holes on the rim of
the motor housing to do so.) This will allow motor
housing to hang out of the way while wiring.
Tip: Seek the help of another person to hold the
stepladder in place and to lift the fan up to you once
you are set on the ladder.
Find a secure attachment point (wood ceiling joist
highly recommended) and secure safety cable. It will
be necessary to use a heavy duty wood screw, washer
and lock washer (not supplied) with the safety cable
loop. If necessary, adjust the loop at the end of the
safety cable. The loop at the end of the safety cable
should just fit over the threads on the wood screw.
Test safety cable by pulling on loose end of cable with
pliers. If the safety cable slips, the loop must be adjusted
smaller. Extra cable slack can be left in ceiling area.
6. Wiring.
WARNING: Turn off circuit breakers to current
fixture from breaker panel and be sure switch is
turned to the OFF position.
CAUTION: Be sure outlet box is grounded properly
and that a ground wire (GREEN or Bare) is present.
Make sure all electrical connections comply with Local
Codes or Ordinances and the National Electrical Code.
If you are unfamiliar with electrical wiring or if the
house/building wires are different colors than those
referred to below, please use a quali ed electrician.
Once fan has been temporarily hung on the
mounting plate, electrical wiring can be made
as follows:
Connect BLACK wire from fan to BLACK wire from
ceiling with wire connector provided.
Connect WHITE wire from fan to WHITE wire
from ceiling with wire connector provided.
Connect GROUND (GREEN) wire from mounting
plate to BARE/GREEN wire from ceiling with wire
connector provided.
Connect BLACK ANTENNA wire from underside
of mounting plate to BLACK ANTENNA wire from
receiver pre-installed inside top of motor housing.
Be sure molex connections snap together securely.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
wood
joist
j-hook
non-slotted
hole
(supply circuit)
WHITE
outlet
box
page 5
safety
cable
loop
wood screw
and washer
motor housing
BLACK
wire
connector
GROUND
(GREEN
OR BARE)
GREEN
mounting
plate
BLACK
WHITE
WHITE
BLACK
motor housing
*
safety
cable

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Cle44Cle52Cole cle44Cole cle52

Tabla de contenido