Preparation For Wiring; Wiring - Craftmade Wyatt Guia De Instalacion

5. Preparation for Wiring.

With wider opening facing up, place housing ring over
top of motor housing. Then, push housing ring down
past top edge of motor housing.
Lift motor housing to mounting plate and then hang
motor housing on j-hook on underside of mounting
plate. (Use one of the non-slotted holes on the rim of the
motor housing to do so.) This will allow motor housing to
hang out of the way while wiring.
Tip: Seek the help of another person to hold the
stepladder in place and to lift the fan up to you once you
are set on the ladder.
Find a secure attachment point (wood ceiling joist highly
recommended) and secure safety cable. It will be
necessary to use a heavy duty wood screw, washer and
lock washer (not supplied) with the safety cable loop. If
necessary, adjust the loop at the end of the safety cable.
The loop at the end of the safety cable should just fit over
the threads on the wood screw. Test safety cable by
pulling on loose end of cable with pliers. If the safety cable
slips, the loop must be adjusted smaller. Extra cable slack
can be left in ceiling area.

6. Wiring.

WARNING: Turn off circuit breakers to current
fixture from breaker panel and be sure switch is
turned to the OFF position.
CAUTION: Be sure outlet box is properly grounded
and that a ground wire (GREEN or Bare) is present.
Make sure all electrical connections comply with
Local Codes or Ordinances and the National Electrical
Code. If you are unfamiliar with electrical wiring or if
the house/building wires are different colors than
those referred to in the diagram to the right, please
use a qualified electrician.
Note: Excess lead wire length from the fan can be cut
to the desired length and then stripped.
Once motor housing has been temporarily hung
on the j-hook on the mounting plate , WIRE THE
RECEIVER with wire connectors provided as shown
in diagram at right.
Tip: While you are wiring, keep in mind that wires
must not obstruct receiver.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
Gently insert receiver (flat side up) into mounting
plate and carefully push wires and taped wire
connectors into outlet box. Let antenna rest
outside of mounting plate.
wood
joist
j-hook
non-slotted
hole
ground (green
or bare)
black
white
pink
yellow
gray
from fan
from
receiver
gray
yellow
pink
white
blue
(wiring for receiver)
page 6
safety
cable
loop
wood screw
and washer
housing ring
motor housing
white supply wire
black supply wire
ground (green or bare)
ground (green)
white
from ceiling
from receiver
antenna
white
AC IN N
black AC IN L
receiver ground (green/yellow)
safety
cable
black
*