Tabla de contenido
Idiomas disponibles
Idiomas disponibles
2.3 Assembling the heater
Before assembling the heater,
make sure the water and gas
connections are properly secu-
red, identified, and positioned.
See the dimensions and con-
nections in section 4.2.
• Fix the plugs and hooks on the wall, in a central po-
sition vertical to the appliance, as shown in the figure
below.
• Mark the position of the bottom screws
• Hang the water heater on the plugs+hooks and tighten
the screws for fixing the unit to the wall.
• Connect the hot and cold water flexible tubes, remem-
bering to check their tightness. To avoid circulation pro-
blems, do not remove the cold water inlet filter.
44
66
60
EN
195
44
Mod. 6 l.
150
66
cod. 3542C090 - Rev. 01 - 09/2022
80
170
mod. 11l.
80
170
90
220
mod. 14l.
90
220
fig. 6 - Dima di montaggio
CADI
80
80
90
90
Tabla de contenido
