Tabla de contenido
t
w
q
q
w
1 Front thrust washer 2 Front propeller
!0
3 Lock washer
5 Rear thrust washer 6 Rear propeller
o
7 Spacer
i
9 Rear propeller nut
u
Installation
y
r
cC
e
8 The combination of front and rear pro-
602064
8 Be sure to install the thrust washers
8 Be sure to use a new cotter pin and
1) Apply Yamaha Marine grease or anti-
2) Shift into forward. Turn the front pro-
3) Install the front thrust washer. Install
602071*
1 Center line
4) Install the lock washer on the pro-
602034
4-19
peller pitch should not be changed. Set
up each propeller properly. If the pro-
pellers are not installed correctly,
engine or propeller could be damaged.
before installing propellers. Otherwise,
lower case and propeller boss may be
damaged.
bend the ends over securely. Other-
wise, the propeller could come off dur-
ing operation and be lost.
corrosion grease to the propeller-
shafts.
peller shaft clockwise until free play is
removed.
front propeller with one blade point-
ing up and its trailing edge aligned
with the center line of lower case.
peller-shaft. Shift into neutral and
tighten the front propeller nut using
the special wrench with a force of 20
Kg (44 lb) which is equivalent to the
specified torque with a conventional
torque wrench.
GB
4 Front propeller nut
8 Washer
0 Cotter pin
2 Trailing edge
Tabla de contenido
