Husqvarna Soff-Cut 2000 Manual De Usuario página 20

wear or a damaged tri-arbor hole. Discard a
defective blade.
Examine the blade flanges for damage and excessive
wear and make sure that the blade flanges are clean.
Cutting blades are not included with the product.
Use only original Husqvarna cutting blades. Refer to
Technical data on page 32 for the correct type for your
model.
Note
If you have the blade block guard, a blade and a
skid plate installed, refer to
on page 18 .
1. Put the included blade wrench on the blade shaft
bolt in the blade block.
2. Use the blade wrench to turn the blade shaft
counterclockwise while you push the locking pin. The
locking pin will fall down and lock the blade shaft.
20
To remove the cutting blade
3. Put the new cutting blade (C) tightly against the inner
flange on the blade shaft (D). Put the outer flange
(B) on the blade shaft. Make sure that the outer
flange is tightly installed to hold the cutting blade in
position and attach the blade shaft bolt (A).
C
D
B
A
4. Turn the blade shaft bolt clockwise with the blade
wrench.
793 - 001 - 19.04.2022