More About Installation; Electrical Connection; Operating Mode; Carbon Filter - THERMEx Cyclone Manual De Instrucciones

74 THERMEX Cyclone

MORE ABOUT INSTALLATION

Follow the steps below, in conjunction with the other installation instructions, to install the device.
1. Unpacking the device. Remove the device from the packaging using the two recesses in the packaging to avoid damaging the glass.
2. Check that all parts are included in the box.
3. Requirements for the cut-out:
Table tops must be made of heat-resistant material (100 ° C).
The material of the table top must not be able to swell on contact with moisture.
Follow the tabletop manufacturer's instructions.
4. Apply insulation strips (not included). Do not turn the unit upside down as this may damage the glass or components of the exhaust tower.
Apply the insulation strips approx. 2 mm from the outer edge to the back of the glass plate.
5. Place the duct bend to the exhaust duct if the exhaust duct is 90 degrees down
6. Insert the device. Place the unit in the tabletop. Tilt it slightly so that it fits into the openings, first back then forward. The flue can now be
connected.

ELECTRICAL CONNECTION

Installation and connection to the mains may only be carried out by a specialist (electrician).
Switch off the main switch or the relevant fuse before connecting the device.
Then connect the device as shown in the following table and the circuit diagram.
WARNING!
Insert the cables correctly and tighten the screws securely. We cannot be held responsible for accidents that can be traced back to a poorly
established or incorrect connection. We accept no liability for accidents caused by devices without earth connection or with defective earth
connection.

OPERATING MODE

The hood can be used both as an exhaust air device and as a circulating air device.
IMPORTANT INFORMATION ABOUT EXHAUST:
! Use the shortest possible piping.
! Use a tube with as few bends as possible (max. Angle of curvature: 90 °).
! The inner surface of the pipe must be as smooth as possible.

CARBON FILTER

Use an active recycle filter available from Thermex. The active recirculation filter cleans the intake air of grease particles and cooking fumes
before sending them back into the kitchen.
M 525231082215092021