Starting Up/Operating - Columbus KS 90 VM 60 Instrucciones De Montaje

Afterwards, open the tank nozzle located in the front part of the
machine.
Top up approx. 1 litre unleaded regular fuel.
Please note that the engine was already filled with approx. 100 ccm
universal lubricant – 15W40 at the factory.
4. Starting Up / Operating
After the machine has been assembled, it is immediately ready for
operation.
First of all, the two lateral brushes should be lowered. For this purpose,
push the thumb washer forward (see Figure) with your foot until the
brushes just touch the floor.
It is possible to adjust the height of the main sweeping brush using the
adjustment handle on the left side of the machine (under the dirt
collector) (see Figure). Please ensure that the brush tips only touch the
floor lightly. If the brushes are adjust too low, this increases the wear on
the brushes and the gear components as well as the power
consumption. Position 1 - the highest brush position (for new, unworn
rollers), position 5 - the lowest brush position (for worn brushes or very
uneven floors for a short period of time).
Put the cold starter (A) into the upper position.
After this, keep pressing in the gasoline pump (C) until the resistance
has noticeably increased. Subsequent to this, rapidly pull the reversing
starter (B) to the end stop. If the motor does not immediately start up,
put the cold starter back into the original position and pull the reversing
starter again to the end stop.
As soon as the motor is running "true", put the cold starter (A) back into
the lower position if this has not already taken place.
If necessary, e.g. in the case of extreme cold, repeat the procedure
as described above until the motor starts.
Steering drive:
The machine starts moving when you carefully pull the steering handle
towards you. Check the behaviour of the steering drive especially when
it is used for the first time so that the machine remains under control.
We recommend that you loosen your grip on the steering handle
slightly when going around curves to lower the speed in the curve. You
will quickly notice that it is easy to operate and move the machine with
or without using the steering drive. If there is more dirt, you should push
the machine over the dirty place more slowly to achieve the optimum
cleaning effect.
In order to move it backwards, loosen the steering handle and pull the
machine in the desired direction.
12