Replacing The Starter Rope And Rewind Spring - Stihl SR 430 Manual De Instrucciones

Replacing the Starter Rope
and Rewind Spring
Replacing the Starter Rope
1
1
2
1
N
Take out the screws (1).
N Remove the starter cover (2).
N Use a screwdriver or suitable pliers
to remove the spring clip (3) from
the starter post.
The rewind spring may pop out
and uncoil during this operation –
take care to avoid the risk of
injury.
N Carefully remove the rope rotor with
washer (4) and pawls (5).
N Use a screwdriver to pry the rope
out of the starter grip.
N Remove the remaining rope from
the rotor and starter grip.
SR 430, SR 450
N Thread the new rope through the
starter grip and tie one of the special
knots shown.
N Pull the knot back into the grip.
N Thread the end of the rope through
the top of the guide bushing (6) and
rope rotor (7) and secure it with a
simple overhand knot.
N Coat the rope rotor bearing bore
with non-resinous oil.
N Slip the rotor over the starter
post (8) – turn it back and forth to
engage the anchor loop of the
rewind spring.
English
33