Stihl SR 430 Manual De Instrucciones página 9

Preparing chemicals
Prepare chemical solutions of according
to manufacturer's instructions.
– Only prepare sufficient solution for
the job at hand so that nothing is left
over.
– Mix chemicals only in accordance
with instructions – wrong mixtures
can produce toxic fumes or
explosive mixtures.
– Never spray chemicals undiluted.
– Prepare solution and fill the
container outdoors only, in well-
ventilated locations.
Storage
– Do not store spray solution in the
container for longer than one day.
– Store and transport spray solution
only in approved containers.
– Never store the spray solution in
containers intended for foods,
drinks or animal feed.
– Do not store spray solution with
foods, drinks or animal feed.
– Keep spray solution out of the reach
of children and animals.
– Store the spray solution in a place
secured against unauthorized use.
Disposal
Never dispose of residual chemicals or
contaminated rinsing solutions in
waterways, drains, sewers, street
gutters or manholes.
SR 430, SR 450
Disposal of contaminated rinse should
be in accordance with all applicable
laws, regulations and ordinances.
Observe the precautionary instructions
of the chemical manufacturer.
THE USE OF THE POWER TOOL
Transporting the Power Tool
Always switch off the engine before
taking the machine off your back and
putting it down. Empty container when
transporting it in a vehicle; properly
secure it to prevent turnover, fuel
spillage and damage to the unit.
Fuel
Your STIHL power tool uses an oil-
gasoline mixture for fuel (see the
chapter on "Fuel" in this instruction
manual).
Warning!
Gasoline is an extremely
flammable fuel. If spilled
and ignited by a spark or
other ignition source, it
can cause fire and seri-
ous burn injury or
property damage. Use extreme caution
when handling gasoline or fuel mix. Do
not smoke or bring any fire or flame near
the fuel or the power tool. Note that
combustible fuel vapor may escape
from the fuel system.
Fueling Instructions
Warning!
To reduce the risk of serious injury from
burns, never attempt to refuel the unit
until it has been completely removed
from the operator.
Warning!
Fuel your power tool in well-ventilated
areas, outdoors. Always shut off the
engine and allow it to cool before refu-
eling. Gasoline vapor pressure may
build up inside the fuel tank depending
on the fuel used, the weather conditions
and the tank venting system.
In order to reduce the risk of burns and
other personal injury from escaping gas
vapor and fumes, remove the fuel filler
cap on your power tool carefully so as to
allow any pressure build-up in the tank
to release slowly. Never remove the fuel
filler cap while the engine is running.
Select bare ground for fueling and move
at least 10 feet (3 m) from the fueling
spot before starting the engine. Wipe off
any spilled fuel before starting your
machine.
Warning!
Check for fuel leakage
while refueling and dur-
ing operation. If fuel
leakage is found, do not
start or run the engine
until the leak is fixed and
any spilled fuel has been wiped away.
Take care not to get fuel on your cloth-
ing. If this happens, change your
clothing immediately.
English
7