Fueling - Stihl SR 430 Manual De Instrucciones

English
water cooled and air cooled engines
(e.g., outboard motors, snowmobiles,
chain saws, mopeds, etc.).
Take care when handling gasoline.
Avoid direct contact with the skin and
avoid inhaling fuel vapor. When filling at
the pump, first remove the canister from
your vehicle and place the canister on
the ground before filling. Do not fill fuel
canisters that are sitting in or on a
vehicle.
The canister should be kept tightly
closed in order to avoid any moisture
getting into the mixture.
The machine's fuel tank and the canister
in which fuel mix is stored should be
cleaned as necessary.
Fuel mix ages
Only mix sufficient fuel for a few days
work, not to exceed 3 months of storage.
Store in approved fuel-canisters only.
When mixing, pour oil into the canister
first, and then add gasoline. Close the
canister and shake it vigorously by hand
to ensure proper mixing of the oil with
the fuel.
Gaso- Oil (STIHL 50:1 or equiva-
line lent high-quality oils)
US gal. US fl.oz
1 2.6
2 1/2 6.4
5 12.8
Dispose of empty mixing-oil canisters
only at authorized disposal locations.
16

Fueling

Preparations
Before fueling, clean the fuel filler cap
and the area around it so that dirt cannot
fall into the tank.
Thoroughly shake up the mixture in the
canister before fueling your machine.
To avoid the risk of burns or other
injuries due to escaping gasoline
vapors, open the fuel filler cap
carefully so that any excess
pressure in the tank can escape
slowly.
Never use a tool to open the
bayonet catch. This could damage
the cap and cause fuel to leak out.
Do not spill any fuel and do not fill the
tank up to the brim.
Open the fuel filler cap
1.
2.
N Press the cap down with your hand
as far as possible, turn it
counterclockwise (approx. 1/8 turn)
and remove it.
Fueling
Take care not to spill fuel while fueling
and do not overfill the tank.
Close the fuel filler cap
1.
2.
N Fit the cap and turn it until it
engages in the bayonet mount.
N Press the cap down with your hand
as far as possible and turn it
clockwise (approx. 1/8 turn) until it
engages completely.
SR 430, SR 450