Stihl SR 430 Manual De Instrucciones página 36

English
N Refit the pawls (5) in the rotor.
N Fit the washer (4) on the starter
post.
N Use a screwdriver or suitable pliers
to install the spring clip (3) on starter
post and engage it on the pawls'
peg – the spring clip must point
counterclockwise as shown in the
illustration.
Tensioning the rewind spring
N Make a loop in the unwound starter
rope and use it to turn the rope rotor
six full revolutions in the direction of
the arrow.
N Hold the rotor steady.
N Pull out and straighten the twisted
rope.
34
N
Let go of the rotor.
N Release the rope slowly so that it
winds onto the rotor.
The starter grip must locate firmly in the
guide bushing. If the grip droops to one
side: Add one more turn on the rope
rotor to increase spring tension.
When the starter rope is fully extended it
must still be possible to rotate the rotor
at least another half turn. If this is not the
case, the spring is overtensioned and
could break.
N Take one turn of the rope off the
rotor.
Replacing a broken rewind spring
The bits of spring may still be
under tension and could fly apart
when you take them out of the
starter cover –
wear face protection and work
gloves.
N Remove the rope rotor.
N
Use a screwdriver to carefully
remove the spring housing (1) and
the parts of the broken spring.
N Lubricate the new spring with a few
drops of non-resinous oil.
N
Position the replacement spring
with spring housing in the starter
cover.
N Fit the rope rotor, tension the rewind
spring, fit the starter cover and
secure it in position.
SR 430, SR 450