Unpacking And Inspection - PeakTech 1655 Manual De Instrucciones

1.2. max. Input Limits
Function
A AC
A DC
V DC; V AC
Resistance, Capacitance, Diode Test
Type K Temperature
CAUTION!
Note on using the supplied safety test leads according the IEC / EN 61010-031:2008:
Measurements in the field of overvoltage category CAT I or CAT II can be performed with test
leads without sleeves with a maximum of up to 18mm long, touchable metallic probe, whereas for
measurements in the field of overvoltage category CAT III or CAT IV test leads with put on sleeves,
printed with CAT III and CAT IV must be used, and therefore the touchable and conductive part of
the probes have only max. 4mm of length.
2. Introduction
This clamp meter is a handheld instrument that is designed for use in the laboratory, field servicing,
at home, and any circumstance where high current measurement is required. The clamp meter is
built with a design of finger guard which ensures users operating the instrument under a safety
situation; a rugged case that is shock resistant and fire-retardant; and electronic overload
protection for all functions and ranges. In addition, a carrying case is available for easy portability of
the meter and avoiding damage.

2.1. Unpacking and inspection

Upon removing your new digital clamp meter from its packing, you should have the following items:
1 Digital clamp meter
1 Test lead set (one black, one red)
1 Battery
1 Carrying case
1 Thermocouple
1 Instruction manual
If any of the above items are missing or are received in a damaged condition, please contact the
distributor from whom you purchased the unit.
Maximum Input
1500 A DC/AC
1500 A DC/AC
1000 V DC/AC
1000 V DC/AC
30 V DC, 24 V AC
-22-