PeakTech 1655 Manual De Instrucciones página 26

8 Non-Contact Voltage Detector
WARNING: Risk of Electrocution. Before use, always test the Voltage Detector on a
known live circuit to verify proper operation.
Rotate the Function switch to any measurement position.
Place the detector probe tip on the conductor to be tested.
If AC voltage is present, the NCV detector will turn on with a steady red light.
NOTE: The conductors in electrical cord sets are often twisted. For best results, move
the probe tip along a length of the cord to assure placing the tip close to the live
conductor.
NOTE: The detector is designed with high sensitivity. Static electricity or other sources of
energy may randomly trip the sensor. This is normal operation.
9 LED light to indicate for the Non-Contact-Voltage Detector
10 Function switch
To select the desired measurement function.
11 HOLD button
Press HOLD button to toggle in and out of the Data-Hold mode. In the Data-Hold mode,
the "HOLD" annunciator is displayed and the last reading is frozen on the display. Press
the HOLD button again to exit and resume readings.
12 °C/°F-button
To switch between °C and °F
13 Backlight button
After turning on the backlight with "backlight" (icon) button, it turns off automatically after
about 30 seconds.
14 ZERO-button
To activate the zero adjustment the display for the measurement functions of DC current
and capacity.
15 PEAK-button
When ACA or ACV is selected, pressing the PEAK button enables the peak capture
circuit. The meter will now capture and display the maximum and minimum peaks of the
waveform.
-25-