Operation; Placement Of The Power Supply; Before Placing The Cleaner Unit In The Water; Placing Cleaner In The Water - Pentair PROWLER P10 Guia Del Usuario

Placement of the Power Supply

Place the power supply at least 3.5 meters from the pool and at least 12 cm above ground.
CAUTION: The power supply is not water resistant; it must not be exposed to water or to direct sunlight.
Press the plastic snap on the zip ties in order to release the floating cable. Use as much cable as needed in the
the water.

Before placing the cleaner unit in the water

Make sure there are no people in the pool. Make sure that the filters are clean. Make sure the pool conditions are
met; (see "Operating Conditions" ).

Placing cleaner in the water

Unroll the floating cable. It is recommended to extend a length of cable that is equal to the pool diagonal size plus
an additional two meters. Smooth out coils or twists in the cable. Connect the floating cable to the socket located
on the power supply. Roll extra cable, no in the pool, near the power supply. Place the cleaner unit in the pool. Let it
sink to the bottom of the pool. Do not start operation before the robotic cleaner is settled on the pool floor.
CAUTION: Operating the cleaner out of water may cause immediate and severe damage resulting in loss of warranty.
1
2
You may turn on the cleaner
when it reaches the floor.
3
CI
Chlorine
2-4 ppm

OPERATION

Please use as much cable as
needed. Leave the remaining cable
out of the pool.
3.5 m
pH Temp
7.2 – 7.6 13°C - 35°C
PROWLER P10 & P20 Robotic Inground Pool Cleaner Installation and User' s Guide
above ground
NaCI NO SWIMMING
4000 ppm While the robot is
(max) in the pool
3
12 cm