Cleaner Adjustments And Operation; Hose Length - Pentair KREEPY KRAULY WARRIOR Instrucciones De Instalación Y Guía De Usuario

6

CLEANER ADJUSTMENTS AND OPERATION

After installation, turn the pool pump on. The Warrior™ Suction Side Pool Cleaner should be moving about the
pool at a rate of 8 to 12 feet per minute. Be sure to check each of the following initial adjustments.

Hose Length

Note: The pump must be on when you check the
hose length. The hose contracts when the pump is
operating and will be longer when the pump is off.
While the cleaner is operating:
1. Position cleaner at the furthest point of the
pool from where it's attached. Use a pool
pole and brush to easily position the cleaner
in the pool.
2. The hose should be long enough to reach the
end of the pool, plus one hose section and
the leader hose. See Figure 12.
3. Remove any excess hose lengths from the
middle of the hose assembly. This will ensure
you do not alter the position of the hose float.
4. Save extra hose sections for use as needed
for replacement.
Note: Turn pool pump off when adding or
removing hose sections.
KREEPY KRAULY
WARRIOR™ Suction Side Pool Cleaner Installation and User's Guide
®
Figure 12