Troubleshooting; Corrective Action - Pentair PROWLER P10 Guia Del Usuario

8
Problem Possible Cause
CLEANER DOES NOT
There is no electricity in the wall
TURN ON
socket:
Obstacle in the drive system of the
cleaner unit:
Propeller is seized due to accumula-
tion of hair:
CLEANER MOVES
Filters are dirty:
BUT DOES NOT PUMP
Propeller is broken or seized due to
WATER
accumulation of hair:
CLEANER PUMPS
Obstacle in the drive system of the
WATER BUT DOES NOT
cleaner unit:
MOVE
CLEANER STARTS
Filters are dirty:
AND SHUTS OFF
AFTER A SHORT TIME
Propeller is broken or seized due to
accumulation of hair:
Obstacle in the drive system of the
cleaner unit:
CLEANER DOES NOT
Filters are dirty or have holes:
PICK UP DIRT
Propeller is broken or seized due to
accumulation of hair:
CLEANER UNIT DOES
Floating cable is to short:
NOT COVER THE
ENTIRE POOL
Propeller is broken or seized due to
accumulation of hair:
THE CLEANER DOES
NOT CLIMB WALLS
PROWLER P10 & P20 Robotic Inground Pool Cleaner Installation and User' s Guide

TROUBLESHOOTING

Corrective Action

(1) Disconnect cleaner from the power and
control unit. (2) Disconnect power supply
from the wall socket, wait 30 seconds and
reconnect. (3) Turn power on. If not activated,
connect the unit to a different wall socket.
(1) Turn the cleaner unit carefully to view the
bottom side. (2) Check that the scrubbing brush
is not bent/broken. (3)Clean and remove obsta-
cles and debris if necessary.
Check if the propeller is broken or needs to be
cleaned (see "Checking Water Outlet Propeller").
(1) Remove the filters and clean them.
Check if the propeller is broken or needs clean-
ing (see "Checking Water Outlet Propeller").
(1) Turn the cleaner unit carefully to view
the bottom side. (2) Check that the scrub-
bing brush is not bent/broken. (3) Clean and
remove obstacles and debris if necessary.
(1) Remove and clean the filters. (2) Restart
the robot and try again.
(1) Remove the top screws on the top outlet.
(2) Check if the propeller is broken or needs to
be cleaned.
(1) Turn the cleaner unit carefully to view
the bottom side. (2) Check that the scrub-
bing brush is not bent/broken. (3) Clean and
remove obstacles and debris if necessary.
Clean as needed and verify that there are no
holes in the filters.
Check if the propeller is broken or needs clean-
ing (see "Checking Water Outlet Propeller").
(1) Verify that there is enough length of the floating
cable in the water to reach the far end of the pool.
(2) Make sure that the floating cable is properly
spread out and is not tangled.
(1) Remove the top screws on the top outlet.
(2) Check if the propeller is broken or needs
cleaning.
(1) Verify that your robotic cleaner is not a
floor-only model. (2) Verify that Program 1,
floor cleaning only, is not selected on the
power supply unit. (3) Make sure to clean the
filters (4) Make sure propeller isn't broken or
tied up to debris/hair.