Operation - Ryobi RY15518 Manual Del Usuario

rotate from side to side until the button is locked into
place.
 Tighten the knob securely.
WARNINg:
Be certain the knob is fully tightened before operating
equipment. Check it periodically for tightness during use
to avoid serious injury.
REMOVINg ThE ATTAChMENT FROM ThE
POWER hEAD
For removing or changing the attachment:
 Stop the engine.
 Loosen the knob.
 Push in the button and twist the shafts to remove and
separate ends.
WARNINg:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNINg:
Always wear safety goggles or safety glasses with side
shields when operating power tools. Failure to do so could
result in objects being thrown into your eyes resulting in
possible serious injury.
WARNINg:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
APPLICATIONS
You may use this product for the purpose listed below:
 Edging around walkways, curbing, flower beds and other
similar areas.
USINg ThE EDgER ATTAChMENT
See Figure 4.
When using the edger attachment, hold the unit with your
right hand on the rear handle and your left hand on the front
handle. Keep a firm grip with both hands while in operation.
The edger should be held at a comfortable position with the
rear handle about hip height.
NOTE: Always operate at full throttle. Prolonged cutting at
partial throttle will result in oil dripping from the muffler.
All manuals and user guides at all-guides.com

OPERATION

ADJUSTINg DEPTh OF CUT
See Figures 5 - 6.
To adjust the blade depth:
 Stop the engine and remove the spark plug wire or dis-
 Loosen the adjusting knob and move the wheel arm up
7 — English
adjusting
knob
blade
depth
curb guide
connect from the power source.
to increase the depth or down to decrease the depth.
Fig. 4
to increase
depth
to decrease
depth
wheel arm
Fig. 5
blade
Fig. 6