Assembly - Ryobi RY15518 Manual Del Usuario

UNPACKINg
This product requires assembly.
 Carefully remove the items from the box. Make sure that
all items listed in the packing list are included.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
 If any parts are damaged or missing, please call
1-800-860-4050 for assistance.
PACKINg LIST
Edger Head
Edger Attachment Shaft
Holding Pin
Hex Wrench
Operator's Manual
WARNINg:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Failure to heed this warning could result in serious personal injury.
WARNINg:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
JOININg ThE EDgER ATTAChMENT TO ThE
ATTAChMENT ShAFT
See Figure 2.
This product requires a one one-time assembly of the edger
head to the attachment shaft.
 Remove rubber end cap from edger attachment shaft
before installing.
 Install the edger attachment shaft into opening on the
gear head so that the hole on the top of the attachment
shaft lines up with the shaft screw as shown.
 Tighten the shaft screw into the hole on the edger
attachment shaft.
NOTE: When the screw is properly installed the screw
head will be completely seated against the casting. If this
is not the case, the screw is not installed properly.
 Tighten securely by turning the gear head screw to clamp
gear head around shaft.
NOTE: When fully secure, the shaft cannot be rotated.
All manuals and user guides at all-guides.com

ASSEMbLY

JOININg ThE POWER hEAD TO ThE EDgER
ATTAChMENT
See Figure 3.
The edger attachment connects to the power head by means
of a coupler device.
 Remove the hanger cap from the attachment.
 Loosen the knob on the coupler of the power head
 Push in the button located on the edger attachment. Align
6 — English
gear head
screw
shaft
screw
gear head
edger head
power head shaft
guide recess
button
positioning
hole
edger
attachment
WARNINg:
Never attach or adjust any attachment while power head
is running. Failure to stop the engine may cause serious
personal injury.
shaft.
the button with the guide recess on the power head cou-
pler and slide the two shafts together. Rotate attachment
shaft until button locks into the positioning hole.
NOTE: If the button does not release completely in the
positioning hole, the shaft is not locked into place. Slightly
hole
edger attachment
shaft
Fig. 
coupler
knob
Fig. 3