Getting Started; Step 1: Inserting Batteries Into The Remote Control; Using The Remote Control; Step 2: Turning On The Power - Yamaha DVD-S661 Manual De Instrucciones

Getting Started

Getting Started
Step 1: Inserting batteries into
the remote control
1
1
Open the battery compartment.
2
Insert the two supplied batteries (AAA,
R03, UM-4) following the indications
(+/–) inside the compartment.
3
Close the cover.
Notes
• Insert batteries correctly according to the polarity
markings (+/–). Batteries inserted in the opposite
orientation may leak.
• Replace the exhausted batteries immediately with
new ones to prevent leakage.
• Remove the batteries from the compartment if the
remote control is not used for more than a month.
• If the batteries have leaked, dispose of them
immediately. Avoid touching the leaked material
or letting it come into contact with clothing, etc.
Clean the battery compartment thoroughly before
installing new batteries.
• Do not use old batteries together with new ones.
• Do not use different types of batteries (such as
alkaline and manganese batteries) together. Read
the packaging carefully as these different types of
batteries may have the same shape and color.
• Dispose of the batteries correctly in accordance
with your local regulations.
12
En
3
2 2

Using the remote control

Use the remote control within 6 m
(approximately 20 ft) of this unit and point it
toward the remote control sensor.
Within 6 m
(approximately 20 ft)
Notes
• Do not spill water or other liquids on the remote
control.
• Do not drop the remote control.
• Do not leave or store the remote control in the
following types of conditions:
– places of high humidity, such as near a bath
– places of high temperature, such as near a
heater or stove
– places of extremely low temperature
– dusty places
• When the remote control works unstably, point it
at an angle upward to the sensor.

Step 2: Turning on the power

1
Plug the power cable into the AC outlet.
2
Turn on your TV and AV receiver.
3
Select the appropriate input source of the
AV receiver (refer to the manual supplied
with your AV receiver).
4 Press STANDBY/ON on the front panel or
on the remote control to turn on this
unit.
➜ The front panel display lights up.
5
Set the TV to the correct video input (refer
to the manual supplied with your TV).
➜ The default screen appears on the TV.