50 20
4.2.5.3- Super chlorinating
Select this opti on if you require super-chlorinati on of your swimming pool, bearing in mind the
following:
•
If the equipment is working in semi-automati c mode (with the NTC PROBE KIT ), the
equipment will calculate the ti me necessary depending on the volume and Temperature.
The fi ltering ti me to perform super-chlorinati on will be displayed on the screen.
•
Without a Temperature probe, super-chlorinati on will be carried out for 24 hours. If
fi ltering is disconnected, super-chlorinati on is suspended.
4.2.5.4- Calibration of the free chlorine probe
If you have a free chlorine probe, a menu will appear for you to calibrate it.
Pulse OK
cuando estabilice
ppm: 1.21
Once the reading has stabilized and the chlorine measurement has been taken with DPD1, adjust
Cl: 98%
the PPM value provided by the DPD1 measurement.
C1: 1.21ppm
Pulse OK
4.2.6- pH menu
pH: 6.7
With this menu, you can adjust the parameters related to the pH adjustment of
cuando estabilice
your swimming pool. It only appears in SMARTCLORO PH series equipment.
→Menu
ppm: 1.21
4.2.6.1- Main screen
The reading of the pH probe can be seen in the 3rd line of the main screen.
pH + -
→
Cl: 98%
Calibración
C1: 1.21ppm
Manual
pH: 6.7
pH ON/OFF
→Menu
pH adjustment does not start up unti l 5 minutes aft er the equipment has been switched on.
pH + -
→
Calibración
A proporti onal+integral control automati cally adjusts the pH without the need for controller
Manual
adjustments. The pump will start up every minute and with a variable operati on ti me of between
0 and 60 seconds.
pH ON/OFF
ATTENTION:
The probe and the equipment are calibrated in the factory. New calibrati on should be done
on changing the probe.
7.4V
Auto.
Relé OFF
16 : 20
7 . 3
7.4V
Auto.
Relé OFF
ON ↓
16 : 20
7 . 3
ON ↓
pH cal. = 7
pH = 7 . 0
Pulse OK
cuando estabilice
pH cal. = 4
pH =
4 . 1
pH cal. = 7
Pulse OK
pH = 7 . 0
Calibración OK
Pulse OK
cuando estabilice
pH cal. = 4
pH =
4 . 1
Pulse OK
Calibración OK