Intended Use; Initial Use - Würth EWS 10-125 COMPACT Traducción Del Manual De Instrucciones De Servicio Original

Emission values
These values make it possible to assess the emissions from the power tool and to compare different power tools.
Depending on the operating conditions, the condition of the power tool or the accessories, the actual load may be
higher or lower. For assessment purposes, please allow for breaks and periods when the load is lower. Based on
the adjusted estimates, arrange protective measures for the user e.g. organisational measures.
Art.
a /K *
h, SG h, SG
a /K *
h, DS h, DS
L /K
pA pA
L /K
WA WA
Vibration total value (vector sum of three directions)
determined in accordance with EN 60745:
a , = Vibration emission value (surface grinding)
h SG
a , = Vibration emission value (grinding with grinding disc)
h DS
K = Uncertainty (vibration)
h, SG/DS
* The specified vibration emission values:
• Were measured using a standardised test method and can be used to compare one electric tool with another.
• Can be used for a rough assessment of the exposure.

Intended Use

This device is only to be used as a grinder, sander,
for work with wire brushes and for cut-off machin-
ing of metal, concrete, stone and similar materials
without the use of water. Use only original Würth
accessories. Any other use or use outside this scope
is considered an improper use.
The user is solely responsible for damage
resulting from improper use.
Device elements (Fig. I/II)
1 Trigger switch for switching ON/OFF
2 Wheel for speed setting**
3 Trigger switch**
4 Switch-on inhibitor**
5 Rubber plate with abrasive sheet*
6 Cup brush*
7 Auxiliary handle/auxiliary handle with vibration
damping**
8 Two-hole wrench**
9 Two-hole nut**
10 Quick-clamping nut (Q-Nut)**
11 Abrasive wheel*
12 Cut-off safety hood clip*
13 Safety hood
14 Supporting flange
15 Spindle
16 Spindle locking knob
17 Locking lever
* Accessory, not included in the scope of delivery
** depending on the model
5707 003 X 5707 004 X 5707 005 X 5707 006 X 5707 007 X
m/s 6.0/1.5
2
m/s < 2.5/1,5
2
93.0/3
dB (A)
104.0/3
dB (A)
6.0/1.5 6.0/1.5
< 2.5/1,5 < 2.5/1,5
94.5/3 93.0/3
105.5/3 104.0/3
Typical A-effective perceived sound levels:
L
pA
L
WA
K ,K
pA WA
Before initial use, check that the specifications of
your mains power supply correspond to the mains
voltage and mains frequency indicated on the
name plate.
Attaching auxiliary handle
Risk of severe injuries.
Work only with the auxiliary
¾
handle [7] attached!
▸
Screw in the auxiliary handle firmly on the left-
hand or right-hand side of the machine.
Attaching the safety hood (Fig. II)
Risk of severe injuries.
For safety reasons, use only the safety
¾
hood intended for the respective
grinding wheel!
6.0/1.5
< 2.5/1,5
93.0/3
104.0/3
= Sound pressure level
= Sound power level
= Uncertainty

Initial Use

Attention!
CAUTION!
CAUTION!
Use only attachments with a
clearance of at least 3.4 mm
to the safety hood.
6.8/1.5
3.0/1.5
93.0/3
104.0/3
21