Cleaning You Gel Coat Bath Whirlpool; Cleaning Your Vikrell Bath Whirlpool; Cleaning Your Kohler Softgrip Handles - Kohler K-1106 Guia Del Usuario

Cleaning Your Acrylic Bath Whirlpool (cont.)
Avoid detergents, disinfectants, or cleaning products in aerosol cans.
Consider using Fantastik
rust removal consider using Super Iron Out
NOTICE: Failure to comply with these cleaning instructions may void Kohler's warranty obligations.
NOTE: Success with cleaners and procedures is dependent upon such factors as the hardness and
temperature of the water, using exact quantities of ingredients, changes in cleaning formulas, and the
condition of the product being cleaned. Since there are variations within these factors, Kohler cannot
guarantee the effectiveness of the formulas mentioned.

Cleaning You Gel Coat Bath Whirlpool

Do not use abrasive cleansers or solvents on gel coat surfaces.
Wipe out your gel coat product with a soft cloth after each use.
If the surface gets excessively dirty you can use a general purpose cleaner such as: Formula 409
Purpose Cleaner, Gel Gloss
Clean Lemon Fresh, Cinch
®
automotive-type polishing compound, followed by an application of good-quality paste wax.
Avoid cleaning products that contain the following chemicals, as they will damage the finish of your
gel coat product: acetone, ethyl alcohol, amyl or ethyl acetate, sodium hypochlorite, toluene, or
phenol.
Extreme heat such as that generated by cigarettes or portable heaters can damage gel coat surfaces;
do not use such items near your gel coat unit.

Cleaning Your Vikrell Bath Whirlpool

Do not use abrasive cleansers or solvents on Vikrell surfaces.
Wipe out your Vikrell product with a soft cloth after each use.
If the surface of your Vikrell product becomes dull, use an automotive-type polishing compound,
followed by an application of good-quality paste wax.
Avoid cleaning products that contain the following chemicals, as they will damage the finish of your
Vikrell product: acetone, ethyl alcohol, amyl or ethyl acetate, sodium hypochlorite, toluene, or
phenol.
Extreme heat such as that generated by cigarettes or portable heaters can damage Vikrell surfaces;
do not use such items near your Vikrell unit.

Cleaning Your Kohler SoftGrip Handles

Wipe your SoftGrip handles with mild soap and water for general cleaning. If the surface gets
excessively dirty, use a soft bristle brush with a multi-purpose, non-abrasive cleanser or an
automatic dishwasher detergent powder.
1010564-5-G
All Purpose, Lysol Bathroom Cleaner, or Tilex
® ®
Multi-Purpose Rust Stain Remover.
®
Care Tip: To restore dull or scratched units:
Apply white automotive polishing compound
with a clean cloth. Rub scratches and dull areas
vigorously. Wipe off residue. Follow with a
coat of white automotive paste wax. Do not
wax areas where you walk or stand. Damaged
surfaces can be repaired. Check the Yellow
Pages under "Fiberglass-Repair."
(Bath and Shower only), Scrub Free
®
, Glass Plus , or Fantastik
® ®
Soap Scum Remover. For
®
Mildew Stain Remover, Mr.
®
All Purpose. You can also use an
®
6
All
®
Kohler Co.