Nice TTDMD Instrucciones Y Advertencias De Instalación Y Uso página 3

1
2
"V"
4 - LEARNING THE TECHNICAL CHARACTERISTICS
OF CONNECTED LAMPS
After installing and connecting the dimmer, it must be told to which type of lamp it
is connected. The following two procedures memorize the technical characteristics
of the lamps in the dimmer; this is necessary for the system to operate correctly
(minimum/maximum brightness, illumination curves, etc.). Each type of lamp behave
differently at a given power setting: for example, if the brightness is set to 10%, an
incandescent lamp will turn on, but a led will most likely not do so.
4.1 - Location of jumpers
01. Shut off power to the dimmer (all work must be done with power to the
unit shut off).
02. Undo screw "V" and remove the top cover by rotating it up (see fig. 2).
03. In Table A: identify the type of lamp in question.
04. On the dimmer: set jumper "JP1" (already present on the dimmer) to the position
indicated in Table A.
For the "minimum brightness" set on the dimmer, refer to Table A.
4.2 - Learning the type of lamp connected
The dimmer is factory set to control incandescent lamps from 1 to 150 Watt. To
select a different type of lamp, proceed as follows.
01. Press and hold down the dimmer button: wait 5 seconds for the led to turn on
and then turn off. Now release the button.
02. Press and hold down the dimmer button: wait 5 seconds for the led to turn on
and then another 5 for it to turn off; wait for the led to flash 3 times and release
the button.
03. Press and hold down the dimmer button: wait 5 seconds for the led to turn on
and then another 5 for it to turn off; wait for the led to flash 2 times and release
the button.
04. Select the type of lamp you wish to program from the list and slowly press the
dimmer's button the number of times indicated for that type:
• Incandescent lamp, 150W - 350W = 1 press.
• Incandescent lamp, 1W - 150W = 2 presses.
• Led lamp = 3 presses.
• Fluorescent lamp = 4 presses.
Wait for 10 seconds for the led to flash the same number of times.
05. Press and hold down the dimmer button: wait 5 seconds for the led to turn on
and then turn off. Now release the button. To confirm the procedure, the led will
flash twice.
To change the type of lamp: first check the setting of jumper JP1 (par. 4.1) and
then repeat the procedure given in par. 4.2 from the start.
5 - COMPATIBLE TRANSMITTERS AND THEIR OP-
ERATION
5.1 - Compatible transmitters
The dimmer is equipped with NRC 433.92 MHz technology, using a rolling code
encoding; this makes it compatible with the Nice transmitters listed in Table B. Refer
to the Nice catalogue or www.niceforyou.com for further information.
5.2 - Operation of transmitters with sliders
These transmitters, along with conventional control buttons, are fitted with a touch
sensitive capacitive strip. The strip works like a slider, to enable switching lamps on
and off and adjusting their brightness.
• Briefly touching the slider with a finger: sends an absolute positioning command
English – 2