Working With The Machine; Acoustic Warning Signals; Accessories - Festool OSC 18 Manual De Instrucciones

English
1
90°
2
60°
30°
0°
30°
The tool can be offset in 30° increments
and secured in the most effective working
position.
The protection (against accidental contact)
on the saw blade may become twisted if
wear has occurred, see fig. [4]
1
3x
3

10 Working with the machine

Observe the following information:
– Only guide the power tool towards the
workpiece when it is switched on.
– A significant increase in the force required
to advance the machine and slow working
12
click
click
90°
3b
60°
3x
2
3x
5
4
3x
4
progress are indicators that the blades are
worn.
– Hold the power tool by the gripping sur­
face [1-3] with both hands to ensure safe
guidance. Do not cover the cooling air
openings [1-4] with your hand. Otherwise
there is a risk of the machine overheating.
– Do not hold the power tool by the battery
pack.
– Always secure the workpiece in such a way
that it cannot move during machining.

11 Acoustic warning signals

If the power tool switches off due to one of the
following operating states, a warning signal
sounds when switching on the tool and the
power tool switches off again.
Battery pack not accepted
– Insert the correct battery pack model.
Battery pack empty
– Change the battery pack.
– Charge the battery pack.
Battery pack fault
– Change the battery pack.
– Use the charger to check that the battery
pack is fully functional once it has cooled
down.
Battery pack overheated
– Let the battery pack cool down.
Power tool overheated
– You must allow the power tool to cool down
before starting it up again.
Power tool fault
– Contact a Festool service workshop or spe­
cialist dealer.
Power tool jammed
– Eliminate the cause of the jam.
If the power tool switches of when it be­
comes jammed, no warning signal sounds.

12 Accessories

WARNING
Risk of injury
► Remove the battery pack from the power
tool before performing any work on the
power tool.
Use only original Festool accessories and
Festool consumable material intended for this
machine. These components are designed spe­
cifically for this machine. Using accessories
and consumable material from other suppliers