Testing Your Fan - Craftmade Yorktown Guia De Instalacion

9. Switch Housing Assembly. (cont.)
Connect male plug from motor housing to
female plug from switch housing, matching
up the colors on the male plug with the
colors on the female plug for correct fit. Be
sure that the plugs connect completely.
Align holes in switch housing plate with
holes in switch housing. Re-insert screws
that were previously removed and securely
tighten all 4 screws with a Phillips
screwdriver.

10. Testing Your Fan.

It is recommended that you test fan before
finalizing installation. Restore power from
circuit box and light switch (if applicable). Test
fan speeds with pull chain. (diagram 1) Start at
the OFF position (no blade movement). First
pull will set the fan to HI. Second pull will set
the fan to MEDIUM. Third pull will set the fan to
LOW. Fourth pull will again set the fan to the
OFF setting. If fan does not function, please
refer to "Troubleshooting" section to solve any
issues before contacting Customer Service.
Turn fan completely off before moving the
reverse switch. Set reverse switch to recirculate
air depending on the season:
- LEFT position in summer (diagram 2)
- RIGHT position in winter (diagram 3)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower your
thermostat setting in winter without feeling a
difference in your comfort.
Important: Reverse switch must be set either
completely to the LEFT or completely to the
RIGHT for fan to function. If the reverse switch
is set in the middle position (diagram 4), fan
will not operate.
Attach pull chain extension supplied or custom
pull chain extension (sold separately) to the
end of the pull chain.
diagram 1
diagram 2
page 8
motor housing
male
plug
switch
housing
plate
female
plug
switch
housing
reverse
switch
pull chain
extension
diagram 3 diagram 4