Setting The Date And Time - Comelit SK9011/A Manual Tecnico

parameters (as well as those of the transmitter).
Once back to normal Operating Mode, all
transmitters of the same Building will open the
door without any further programming and their
parameters will be stored automatically as they
are first used.
The transmitters have 3 channels, which
correspond to the three buttons marked with the
dots « . » , « .. » and « ... ».
Multi-Building Programming
Typically in a situation with Main and Secondary
entrances, for the Main entrance Receiver it is
possible to program and authorise transmitters
from several Buildings (Max 30). To do this we
simply have to program, one after the other,
transmitters from different Buildings, while the unit
is in PRG mode for Installation.
This way the unit will be programmed with more
Building Codes and all transmitters of those
Buildings can open the door.
2. Adding a transmitter
To add a transmitter later, you just have to
programme it into the SIMPLEKEY software.
Its parameters will be recorded automatically at
the first use.
3. Replacing a transmitter
To delete a transmitter, you just have to select
its location in the SIMPLEKEY software and re-
programme a new transmitter. Its parameters will
automatically replace the old one when it is first
used.
4. Modifying a transmitter's parameters
To modify a transmitter's parameters, you just
have to select it from the SIMPLEKEY software
and re-programme it. Its parameters will be
updated automatically when it is first used.
5. Complete reset
Place S2 in programming mode (LED1 = fixed red)
Keep S1 pressed down for 15 seconds, LED1 will
go out. When LED1 comes back on again, the
reset is complete.
Toggling back to operating mode.
Resetting enables:
• the deletion of one or more building codes.
• the deletion of the transmitter black list.
• the timer to be set to 2 seconds.
• the logical address to be set to 1.
• the password to be set to "0000 ".
4

SETTING THE DATE AND TIME

To work properly the SK9011/A unit's internal clock
must be set correctly. This is set in the factory to
GMT time (universal time) and will be adjusted
automatically to the corresponding time zone in the
place it is being used when it is initialised (first key
swiped).
If necessary, it is, however, possible to set the
time and date manually using the SK9093 software
supplied separately. To do this you just have to
connect to the unit using the cable supplied with the
kit and launch the program.
Click on "Clock" and then follow the instructions
f
to change the setting.
Other functions are possible (changing the password,
reinitialising the unit etc.). Refer to the software
instructions.