General Introduction - Comelit SK9011/A Manual Tecnico

General introduction

The SK9011/A unit is a stand-alone radio frequency
control unit which is used to manage radio
transmitters SK9062B/A and SK9062Y/A. It is used
to control access to a door fitted with an electronic
lock or an automatic device.
It is supplied ready for use. It is initialised at the time
of registration of the first transmitter programmed
using the SIMPLEKEY ADVANCED software on the
unused unit. The other transmitters are then saved
automatically in the memory when they are first
swiped.
It has a 32 bit Wiegand output which is also used to
connect to any type of access control unit using this
protocol. The radio transmitters are then used as a
reader and managed on the unit.
LAYOUT OF THE ELECTRONIC CARD
The card is made up of:
• a switch used to access programming
• two push buttons used to modify the parameters
• two LEDs that show the statuses of the unit
• of connection terminals
• a firmware update connector
ON
S3 S1
1
LED1 LED2
J5
S2
JP2
1 2 3 4 5 6 7 8 9
Description of terminals:
1-2 Power supply 12-24 Vac or 12-33 Vdc
3-4 RS485 network
5-6 Wiegand output D0 and D1
7-8-9 Relay output C/NC/NO
10 RTE button
11 Not used
12 Not used
13 0V
14-15 Antenna
It is necessary to use a separate Power Supply
for the Electric Lock
14 15
10 11 12 13
Installation
The PVC casing of the unit has double-sided
adhesive for rapid fixing as well as two screw holes.
It must be firmly fixed in order to avoid short circuits.
The cables must also be supported.
NORMAL WORKING OF THE UNIT
When the unit is in normal Operating Mode, the Red
LED on the electronic card flashes. If the unit is not
working properly, this LED stops flashing.
In this case, turn the power OFF and then ON again.
If this does not work, please contact our after sales
service department.
The green led confirms that the power is on.
The S2 switch is used to toggle between
programming modes
S2 in position 1: Operating mode
S2 in position ON: Programming mode
Note: In programming mode the LED1 is fixed
red, and in operating mode it is flashing red. When
toggled from one mode to the other, the unit emits a
double beep.
You must go back to operating mode for the unit
to manage access.
SETTING THE OPENING TIMER
To do this, place the S2 switch in the "programming
mode" position. Press the push button S3 as many
times as is needed for the unit to emit the number of
beeps which correspond to the required number of
seconds (e.g.: 25 beeps = 25 seconds). Put the S2
switch back to the "operating mode" position.
The minimum timing setting is 1 second.
The maximum timing setting is 99 seconds.
The unit is supplied with a 2 second opening time
set by the factory.
TRANSMITTER MANAGEMENT
The transmitters must be programmed using the
SIMPLEKEY ADVANCED software contained in the
SK9091 kit so that they can work on the SK9011/A
unit.
Refer to the software programming instructions.
1. Initialisation
The SK9011/A unit is supplied blank and must
be initialised. To do this, you just have to plug it
in, turn it on and press one of the push buttons
on one of the programmed transmitters. The unit
will remain in Programming mode for 15 seconds
(the red LED will flash during this period of time),
in order to allow the initializing of the installation
3