Hoshizaki KM-40B Manual De Instrucciones página 5

ENGLISH
5. WATER SUPPLY AND DRAIN CONNECTIONS
WARNING
Connect to potable water supply only.
* The connections to the mains water supply must be made in
accordance with the countries' current requirements of the Water
Supply or Water Fittings Regulations.
* Icemaking water must be potable water. Where scaling can be
caused by water quality, installation of an external filter or softener
is recommended. Contact your local water treatment professional or
Hoshizaki service agent.
* Water supply pressure should be minimum 0.07 MPa (0.7 bar) and
maximum 0.8 MPa (8 bar). If the pressure exceeds 0.8 MPa (8 bar),
use a pressure reducing valve. Do NOT throttle back the supply tap.
* Be sure to use the new hose-sets supplied with the appliance. Do not
reuse any old hose-sets.
* A plumbing permit and services of a licensed plumber may be required
in some areas.
* Water should drain into an open trap.
* The icemaker drain is gravity flow, so ensure drain pipe has an
adequate pitch or fall.
* To prevent a backflow into the storage bin, the outlet hose must be
laid as shown in Fig. 2.
GOOD
Downgrade
Fig. 2
1) Attach the free end of inlet hose to the stop valve (Fig. 4), noting
washer is correctly positioned. Hand tighten sufficiently to provide
leak free joint. It is a wise precaution to have the stop valve within
easy reach.
2) Hand tighten grey flexible outlet hose (accessory) onto the fitting
on the rear of the icemaker as indicated (Fig. 3), ensuring rubber
sealing washer is correctly positioned to obtain a leak free joint. The
pipe can be cut to length as necessary to suit position of main drain.
To prevent water leaks, secure the outlet hose to the drain outlet by
using a hose band.
Note: Jointing compounds should be approved and suitable for
potable water use.
Power Supply Cord
Outlet Hose
BAD
Upgrade
Power Supply Cord
BAD
II. OPERATING INSTRUCTIONS
1. This icemaker is designed to produce and store edible ice. To
keep the icemaker hygienic:
* Wash your hands before removing ice. Use the plastic scoop
provided (accessory).
* The storage bin is for ice use only. Do not store anything else
in the bin.
* Clean the storage bin before use (see "III. 1. CLEANING").
* Keep the scoop clean. Clean it by using a neutral cleaner
and rinse thoroughly.
* Close the door after removing ice to prevent entrance of dirt,
dust or insects into the storage bin.
4
Drain Outlet
Inlet Hose
European Model
Fig. 3
Water Supply Tap
Inlet Hose
Fig. 4
WARNING