Troubleshooting - Urrea CM1014 Manual De Usuario Y Garantía

E N G L I S H •
Us er's Manual

TROUBLESHOOTING

CUT-OFF SAW WILL NOT START
Tool not plugged in. Plug in Cut-off saw.
Tripped circuit breaker or blown fuse. Reset cir-
cuit breaker or replace fuse.
Power cord damaged. Have power cord re-
placed by authorized service center.
Worn or damaged carbon brushes. Replace car-
bon brushes.
CUT-OFF SAW MAKES UNSATISFACTORY CUTS
Glazed cutting wheel. Dress the wheel or re-
place with a new one.
Workpiece incorrectly clamped in vise. Securely
clamp and support workpiece.
CUT-OFF WHEEL DOES NOT COME UP TO
SPEED
Extension cord too light or too long. Replace
Cord.
Low voltage from AC power source. Consult
certified electrical contractor.
CUT-OFF SAW VIBRATES EXCESSIVELY DUR-
ING CUT
Saw not mounted securely to workbench.
Tighten all mounting hard- ware.
Damaged Cut-off wheel. Replace Cut-off wheel.
Workpiece incorrectly clamped in vise. Clamp
workpiece securely in vise.
CUT-OFF SAW DOES NOT MAKE ACCURATE CUTS
Fence improperly adjusted. Inspect and adjust
fence.
Cut-off wheel not square to fence. Inspect and
adjust wheel.
Excessive force used to make cut. Reduce pres-
sure on cuts; let wheel do cutting.
Workpiece moving.
Clamp workpiece securely in vise.
MATERIAL MOVES DURING CUTTING
Fence slipping or workpiece incorrectly
clamped. Tighten fence.
Vise not securely clamping workpiece. Clamp
workpiece securely in vise.
Excessive force used to make cut. Reduce pres-
sure on cuts; let wheel do cutting.
17