Troubleshooting; Technical Data - Urrea SK816 Manual De Usuario

TROUBLESHOOTING

MOTOR WILL NOT RUN
Problem with ON-OFF switch, power cord, or
outlet. Have worn parts replaced before us-
ing Scroll Saw again. Have the proper outlet
installed by a qualified electrician.
Motor defective. Do not attempt any repair.
Have repaired by a qualified service technician.
BLADES BREAKING
Too much tension. Adjust tension.
Feeding too quickly. Reduce feed rate.
Wrong blade. Narrow blades for cutting thin
wood or tight corners and turns, wide blades
for thicker wood or wide turns.
Blade twisting in wood. Reduce side pressure
on blade, check blade tension.
VIBRATION (there is always some vibration
when the saw is running).
Improper mounting of saw. Check mounting.
Mounting surface. Check mounting in manual.
Loose table or table resting against motor.
Tighten table lock knob.
Loose motor mounting. Tighten mounting
screws.
BLADE RUNOUT (blade not properly aligned
with arm motion).
Blade holders out of line. Realign blade.
E N G L I S H •

TECHNICAL DATA

VOLTAGE-FREQUENCY
BLADE LENGTH
THROAT
STROKE
NO LOAD SPEED
POWER
WEIGHT
U se r's m a n ua l
120 V ~ 60 Hz
127 mm
16" (406 mm)
7/9" (17,5 mm)
(550 - 1 600) r/min
90 W
11,4 kg (25,1 lb)
21