HoMedics BPA-200 Manual De Instrucciones página 9

BPA-200IB_ENGSP.qxd 10/24/05
2. Unwrap the arm cuff. It is pre-formed for easier use.
3. Remove tight fitting clothing from around your upper
left arm. Wrap the cuff around your upper left arm as
shown below. The rubber tube should point in the
direction of your hand. The bottom edge of the cuff
should be 0.8"~1.2" (2~3 cm) above your elbow
with the tube positioned over the middle of your arm.
4. Locate the main artery by pressing with two fingers
approximately 1" (2 cm) above the bend of your
elbow on the inside of your left arm. Identify where
the pulse can be felt the strongest. This is your
main artery.
11:05 AM Page 15
15
5. Position the red area of the cuff on the inside of
your left arm with the artery symbol ( ) over the
main artery.
Main
Artery
6. To secure the cuff, pull the end toward you, wrap it
over the cuff, then press the hook and loop clo-
sure together.
Main
Artery
Pull end toward you,
then wrap over cuff
Note: If it is not possible to fit the cuff to your left
arm, it can also be placed on your right arm.
However, all measurements should be made
using the same arm.
16