Troubleshooting - Garland CHIPPER 100 E-V20 Manual De Instrucciones

9. TROUBLESHOOTING

Depending on the symptoms of the machine we can detect the likely cause and solve the problem.
Problem
The engine stops when started
Machine works sporadically
Performance of the machine is
inadequate
Blade does not turn
Excessive vibrations or noise
In any other case, take the machine to your nearest after sales service.
Cause
Plug or connector in a bad state.
Plug or connector in a bad state.
Cable damaged.
Switch damaged.
Security switch activated.
Cable extension faulty.
Internal cabling faulty.
Switch faulty.
Blunt blade.
Hopper, ejection mouthpiece or blades
blocked.
Blade blocked by strange element.
Screws of the blade loose.
Blades loose.
Blades damaged.
Strange and hard elements blocking
the blades.
33/112
Action
Connect to mains.
Try another plug. If the machine does
not start, take to nearest service agent.
Take the machine to after sales service.
Never repair cable using tape.
Take the machine to after sales service.
Press the restart button.
Check the cable extension and
substitute if necessary. Stop the
machine, disconnect the machine and
check the hopper and blades.
Substitute blades.
Stop the machine, unplug and clean the
shredding conduct and the blades.
Stop the machine, unplug and unblock
the blades.
Tighten the blades following steps in
blade maintenance.
Tighten blades, Change blades.
Clean entry conduct and blades.
English