Makita AN610H Manual De Instrucciones página 7

009177
009178
Nailing of steel plate
WARNING:
Use 2.3 mm (3/32") or les steel for C-shaped one.
•
The tool will bounce severely and a nail struck
back, causing serious injuries.
Use hardened nails only for steel plate. •
Using other purposed nails may cause serious
injuries.
When nailing, hold the tool so that it stands upright
•
to the driving surface.
Slanted nailing may cause nails to strike back,
causing serious injuries.
When fastening a corrugated zinc plate on the
•
C-shaped steel, use 0.7 mm (1/32") or less thick
plate and 32 mm (1-1/4") long hardened nails.
Failure to do so may cause nails to strike back,
causing serious injuries.
Do not use the tool for nailing on ceiling or roof.
•
Choose and use nails more than 10 mm (3/8") longer
than total thickness of all workpiece to be fastened by
referring to the table below.
Material thicknes
(mm)
1.8-22(5/64"-7/8")
10-27(3/8"-1-1/16")
15-30(19/32"-1-3/16")
15-38(19/32"-1-1/2")
009197
1. Change lever
2. Trigger
1
2
1. Change lever
2. Trigger
1
2
Nail length
(mm)
32(1-1/4")
38(1-1/2")
45(1-25/32")
50(2")
4
009187
1
009188
CAUTION:
Depending on the hardness and total thickness of
•
all workpiece in combination to be fastened,
enough fastening may not be obtained. Nailing on
steel plate to excessive depth may extremely
reduce the fastening force. Before nailing, adjust
the nailing depth properly.
In the nailing on the steel plate, the driver may be
•
clogged due to susceptibility to wear. When it is
worn, sharpen it or replace it with a new one.
Nailing of concrete
WARNING:
Use hardened nails only for concrete.
•
Using other purposed nails may cause serious
injuries.Do not nail directly on the concrete or do
not use to fasten directly the steel plate to the
concrete. Failure to do so may cause concrete
fragments to fly off or nails to strike back, causing
serious injuries.
When nailing, hold the tool so that it stands upright
•
to the driving surface.
Slanted nailing may cause concrete fragments to
fly off or nails to strike back, causing serious
injuries.
Do not use on the surface that objects hang from,
•
such as area where hangers for sewer pipe, dust
pipe etc. are set up
Choose and use nails so that the penetration amount
into concrete ranges 10 mm (3/8") - 15 mm (5/8") by
referring to the table below.
7
1. 0.7 mm (1/32")
or less thick for
1
steel plate
2. Thickness of
workpiece
2
3. 10 mm (3/8") or more
4. C-shaped steel
3
(Thickness 1.6
mm (1/16") - 2.3
mm (3/32") )
1. Nail driven to a
proper depth
2
2. Nail driven too
deep will cause
deformation of
workpieces