Technical Specifications; Putting The Machine Into Service; Instructions For Use - Grillo G Z1 Manual De Instrucciones

ENGINE: BRIGGS & STRATTON 575EX OHV 140cc 3HP (Net power SAE J 1349) one-cylinder
petrol engine, silenced muffler, paper air filter
STARTER: recoil starter with Ready Start device
FUEL TANK: 0,8 Litres
GEARBOX: single speed
TRANSMISSION: endless screw in oil bath
CLUTCH: active coupling
HANDLEBAR: height and side – adjustable
STANDARD ROTARY TILLER: with 4 tines and side discs for a total width of 570 mm.
HOES DIAMETRE: 280 mm.
WORKING DEPTH: 280 mm.
ROTARY TILLER R.P.M.: 155 r.p.m.
SAFETY DEVICES: if the handlebar is released the machine stops; mudguards and handlebars
compliant with the current laws and muffler protection.
TRANSPORT WHEEL INCLUDED
WEIGHT: 35 kg
- Check that the machine has not been damaged during transport.
- Fix the spur and turn the handlebar (fig. 3 – fig. 3A).
- Fix the frame to the gearbox (fig. 4)
- Fill in the engine oil (always refer to the engine manual)
- Fill the tank with fuel (fig.1 ref. 3).
BEFORE STARTING THE ENGINE
- check that the air filter is clean (fig. 5).
- check the engine oil level (fig. 6).
STARTING THE ENGINE
- Set the throttle lever in the FAST position (max.).
- Start the engine by pulling the pull-start handle (fig.1 no.6).
- Once the engine is running return the throttle lever almost to the minimum setting.
STARTING WORK
- Adjust the height and side position of the handlebar to get the best working position using the
knob (fig. 1 no.4)
- Adjust the working depth by lowering or raising the rear spur (fig. 3)
- Pull the transfer wheel support to the front and set it into a higher position (fig.8)
- Accelerate the engine (fig.1, no. 2)
- Press the forward lever (fig.2, no.1): the machine starts working.
GZ1/ Translation of the original instructions

TECHNICAL SPECIFICATIONS

PUTTING THE MACHINE INTO SERVICE

INSTRUCTIONS FOR USE

6