Dts Cooling Unit Assembly (Side Attachment) - Pfannenberg DTS Serie Manual De Instrucciones

GB
3.4.3

DTS cooling unit assembly (side attachment)

1
Figure 7 - Switch cabinet exterior view
Holes for DTS cooling unit
Item Designation
1 Holes
3 Cut-outs
Make cut-outs for the DTS cooling unit
Requirements
All general requirements have been fulfilled; see
-
- the unit is de-energized.
Required tools and material
- Saw
- Use a switch cabinet cutter, if applicable
- Protective covers
Procedure
 Use a protective cover to protect the switch cabinet from chips.
 Provide the switch cabinet with cut-outs (3) and holes (1). For the prescribed dimensions (4), refer to the figure
Exterior view of the switch cabinet.
 Deburr the cut edges.
 Remove chips and assembly waste from the switch cabinet.
 Cut-outs and holes have been made.
Operating Manual DTS and DTI 6X2E Premium Controller X-Series (XC) 086100099d © Pfannenberg GmbH
2
1
3
Figure 8 - Switch cabinet exterior view
Item Designation
2 Unit contour
General assembly requirements
Cut-outs for DTS cooling unit
Page 16 / 42