Cleaning The Cooling Unit - Unit Cover Removal - Pfannenberg DTS Serie Manual De Instrucciones

GB
5.2

Cleaning the cooling unit - Unit cover removal

Item Designation
1 Fastening screws
4 Bottom plate slot
Requirement
-
The cooling unit is de-energized.
- Wait for discharging phase of 5 minutes for the electrical components. Only then open the device.
Procedure
 Remove the fastening screws (1).
 Tilt the unit cover (5) forward 20° (2).
 Disconnect the ground cable and connecting cables from the control panel (inside) (3).
 Raise the unit cover about 15 mm and pull it out of the slots in the bottom plate (4).

The unit cover is removed.
Operating Manual DTS and DTI 6X2E Premium Controller X-Series (XC) 086100099d © Pfannenberg GmbH
1
5
Figure – Unit cover removal
19
Item Designation
2 Tilting angle 20°
5 Unit cover
1
2
3
Item
3
4
Designation
Display or operating unit
Page 35 / 42