Dti Cooling Unit Assembly (Installation) - Pfannenberg DTS Serie Manual De Instrucciones

GB
3.4.4

DTI cooling unit assembly (installation)

Item Designation
1 Air inlet
3 Unit contour
Make cut-outs for the DTI cooling unit
Requirements
- All general requirements have been fulfilled; see
The unit is de-energized.
-
Required tools and material
- Saw
- Use a switch cabinet cutter, if applicable
- Protective covers
Procedure
 Use a protective cover to protect the switch cabinet from chips.
 Provide the switch cabinet with cut-outs. For the prescribed dimensions, refer to the figure Exterior view of the
switch cabinet.
 The four corner cut-outs (5) can be rectangular or have a maximum R = 4 mm.
 Deburr the cut edges.
 Remove chips and assembly waste from the switch cabinet.
 Cut-outs have been made.
Operating Manual DTS and DTI 6X2E Premium Controller X-Series (XC) 086100099d © Pfannenberg GmbH
1
3
Figure - Switch cabinet exterior view
10
DTI cooling unit cut-outs
General assembly requirements
2
Item Designation
2 Air outlet
Page 18 / 42