Automatic Mode; Sensor Control; Saturation Display; Lighting - Gaggenau AW 2 Serie Instrucciones De Uso

Automatic mode

Switching on the appliance
#
▯
Press the button.
The fan starts at setting 2.
<
▯
Press the button.
The optimum fan setting 1, 2 or 3 is automatically
set via a sensor.
Switching off the appliance
< #
Press the or button to switch off automatic mode.
The fan switches off automatically if the sensor no
longer detects a change in the air quality of the room.
The automatic mode lasts 4 hours at most.

Sensor control

In automatic mode, a sensor in the extractor hood
detects the intensity of the cooking and roasting fumes.
Depending on the setting of the sensor, the fan
automatically switches to another fan setting.Depending
on the setting of the sensor, the fan automatically
switches to another fan setting.Depending on the
setting of the sensor, the fan automatically switches to
another fan setting.
Default sensitivity setting: 2
Lowest sensitivity setting: 1
Highest sensitivity setting: 4
If the sensor control responds too quickly or too slowly,
it can be changed accordingly:
1 When the fan is switched off, press the
and hold it for approx. 4 seconds. The setting is
displayed.
2 Press the 1, 2, 3 or
of the sensor control.
Button 1 = Sensitivity 1
Button 2 = Sensitivity 2
Button 3 = Sensitivity 3
Ž
= Sensitivity 4
button
3 To confirm the entry, press and hold the
for approx. 4 seconds.
<
Ž
button to change the setting
<

Saturation display

When the metal grease filters are saturated, a signal
sounds for approx. 4 seconds after the fan is switched
œ
off. The
▯
If you have not yet done so, the metal grease filters
should be cleaned now. For instructions on how to
clean the metal grease filters, please refer to the
section
▯
While the saturation indicator is lit up, it can be
reset. To do this, press the

Lighting

The lighting can be switched on and off independently
of the ventilation.
@
Press the
Setting the brightness
Press and hold the
brightness is reached.

Audible signal

Switching on the acoustic signal
When the fan is switched off, press the
same time for approx. 3 seconds. A signal sounds as an
acknowledgement.
Switching off the acoustic signal
Repeat the "Switching on the acoustic signal" process.
button

Cleaning and maintenance

m
Risk of burns!
The appliance will become hot during operation,
especially near the bulbs. Allow the appliance to cool
down before cleaning.
m
Risk of electric shock!
Penetrating moisture may result in an electric shock.
Clean the appliance using a damp cloth only. Before
button
cleaning, pull out the mains plug or switch off the circuit
breaker in the fuse box.
m
Risk of electric shock!
Do not use any high-pressure cleaners or steam
cleaners, which can result in an electric shock.
m
Risk of injury!
Components inside the appliance may have sharp
edges. Wear protective gloves.
saturation indicator also lights up.
.
Cleaning and maintenance
œ
button.
@
button until the desired
button.
# Ž
and at the
19