Eco Control Connecting - Oase AquaMaxEco Expert 20000/12 V Instrucciones De Uso

Connecting the switching power pack to the pump
N O T E
The pump will be destroyed, if water penetrates the plug connectors of the connection line.
• Do not undo the union nuts on the plug connectors.
Once the plug connectors of the filter pump and switching power pack have been inserted and have engaged, they can
only be disconnected by means of a screw driver. (→ Removing the switching power pack)
How to proceed:
 H
• Connect the plug connector of the pump with the plug connector of the switching power pack.
– The stud on the plug connector of the pump engages with the plug connector of the switching power pack.
– The plug connection can later be released with a tool. (→ Removing the switching power pack)

Eco Control Connecting

As an option, Eco Control can be connected to the pump to control it.
• The control unit Eco Control (47673) is available as an accessory for Eco Expert pumps.
• If the pump is integrated in an EGC network, connecting Eco Control is not possible.
How to proceed:
 L
1. Remove the protection cap from EGC-IN.
2. Fit the plug connector of the cable and secure with the two screws (max. 2.0 Nm).
– Ensure that the rubber seal is clean and fits exactly.
– Replace the rubber seal if damaged.
Integrating the pump in the EGC network
N O T E
The device will be destroyed if water penetrates the EGC sockets.
• Close the EGC sockets with EGC plugs or a protection cap.
As an option, the pump can be integrated in an EGC network. In an EGC network, the InScenio FM-Master EGC or
InScenio EGC-Controller and all EGC-compatible devices are connected by means of a Connection Cable EGC. A ter-
minal resistor has to be fitted to the EGC-OUT of the last EGC compatible unit in order to terminate the network.
• The EGC connection cable is available as an accessory in the lengths 2.5 m (47038), 5 m (47039) and 10 m (47040).
• Ensure the correct connection.
How to proceed:
 L, M
1. Remove the protection cap from EGC-IN.
2. Fit the plug connector of the ECG connection cable and secure with the two screws (max. 2.0 Nm).
– Ensure that the rubber seal is clean and fits exactly.
– Replace the rubber seal if damaged.
3. Remove the protection cap from EGC-OUT, fit the terminal resistor and secure it with the two screws (max. 2.0 Nm)
or another EGC compatible unit.
– No Connection Cable EGC is connected to EGC-OUT on the last unit in the EGC network. The terminal resistor
has to be fitted to this EGC-OUT so that the EGC network is correctly terminated.
– The terminal resistor is included in the delivery scope of the InScenio FM-Master EGC or EGC-Controller.
- EN -
21