Features - Urrea EA904 Manual De Usuario Y Garantía

form. Holding the workpiece in your hand or
against your body is unstable, and may lead to
loss of control.
• Keep your hands away of the motion parts.
• Always use goggles and dust mask when you
are grinding, specially when grind over your
head.
• Be careful with the sparks detached of the
disc when work. Hold the grinder such way
that the sparks fly away of you, other persons
or flammable materials.
• Don't touch the work piece immediately af-
ter of the operation, could be very hot and can
cause hurts.
THE KICKBACK
The kickback is a sudden reaction. The punc-
tured or hooked produces a quick decrease
speed rate causing loose control of the tool
which is directed towards the side which is the
operator.
The kickback is the result of an inappropri-
ate tool use or an incorrect operation. Can be
avoided following these instructions:
1. Keep a firm grip with both hands on the
tool. Position your body properly to resist the
force of kickback. The operator can control
torque reactions if the correct warnings are
taken.
2. Never place your hand close to the rotating
accessory. It can cause a kickback over your
hand.
3. Never place your body on the kickback area;
the kickback will propel the tool to the oppo-
site direction of the rotation abrasive disc.
4. Use extra care when working with edges.
These tend to engage the disc.
5. Don't use the tool with cutting saws. These
produce kickback.

FEATURES

KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
1. SAFETY SWITCH-ON/OFF SWITCH
2. SIDE HANDLE.
3. GUARD OF DISC.
4. LOCK-ON SPINDLE BUTTON.
E N G L I S H •
1
4
3
ASSEMBLY INSTRUCTIONS
WARNING: Remove the grinder from the
carton and examine it carefully. Do not discard
the carton or any packaging material until all
parts are examined.
INSTALLING THE SIDE HANDLE
The side handle should always be used during
operation. The side handle can be used in any
one of three positions. Note the positions of
the threaded openings.
Screw the side handle into the right side, the
left side, or the top of the grinder.
ADJUSTING THE GRINDING DISC GUARD
Adjust the guard to protect the operator's
hands and to direct grinding debris away from
the operator.
1. Disconnect the plug from the electrical outlet.
2. Loosen the clamp
screws.
3. Position the guard at
the required angle.
4. Tighten the clamp
screws.
Installing and removing the grinding disc
To install a disc:
1. Disconnect the plug from the electrical outlet.
Make sure that the guard (1) is securely in place.
2. Remove the
outer flange (5).
3. Check that the
inner flange (2) is
properly seated
on the spindle.
It will click into
place on the spin-
dle, and will cause
the spindle to
rotate when the
inner flange is ro-
tated.
U se r's m a nua l
2
7
5
4
2
1
3
6
11