Features - Urrea EB906 Manual De Usuario

rest being properly set. NEVER grind more than
one workpiece at a time.
CHECK DAMAGED PARTS. Before further use
of the tool, a guard or other part that is dam-
aged should be carefully checked to determine
that it will operate properly and perform its
intended function. Check for alignment of
moving parts, binding of moving parts, break-
age of parts, mounting and any other condi-
tions that may affect its operation. A guard or
other part that is damaged must be properly
repaired or replaced by an authorized service
center to avoid risk of personal injury.
NEVER USE IN AN EXPLOSIVE ATMOSPHERE.
Normal sparking of the motor or sparking from
grinding metal could ignite fumes.
NEVER START THE GRINDER when the wheel is
in contact with the workpiece.
SECURE WORK. Always hold workpiece firmly
against the work table.
DO NOT USE THE BENCH GRINDER if the flange
nut or clamp nut is missing or if the spindle
shaft is bent.
FREQUENTLY clean grinding dust from be-
neath grinder.
DO NOT OPERATE THIS TOOL WHILE UNDER
THE INFLUENCE OF DRUGS, ALCOHOL, OR ANY
MEDICATION.
ALWAYS STAY ALERT. Do not allow familiarity,
gained from frequent use of your grinder, to
cause a careless mistake.
ALWAYS REMEMBER that a careless fraction of
a second is sufficient to inflict severe injury.
NEVER reach to pick up a workpiece, a piece
of scrap, or anything else that is in or near the
grinding path of the wheel.
AVOID AWKWARD OPERATIONS AND HAND
POSITIONS where a sudden slip could cause
your hand to move into the wheel. ALWAYS
make sure you have good balance.
NEVER stand or have any part of your body in
line with the path of the wheel.
DO NOT USE TOOL IF SWITCH DOES NOT TURN
IT ON AND OFF. Have defective switches re-
placed by an authorized service center.
DO NOT TURN THE MOTOR SWITCH ON AND
OFF QUICKLY. This could cause the wheel to
loosen and could create a hazard. Should this
ever occur, stand clear and allow the wheel
to come to a complete stop. Disconnect your
grinder from the power supply and securely
E N G L I S H •
retighten the wheel nut.
IF ANY PART OF THIS GRINDER IS MISSING
or should break, bend, or fail in any way, or
should any electrical component fail to per-
form properly, shut off the power switch, re-
move the machine plug from the power source
and have damaged, missing, or failed parts re-
placed before resuming operation.
MAKE SURE THE GRINDER IS SECURELY
MOUNTED as described in the operating in-
structions before connecting the tool to a
power supply.
DO NOT OVERTIGHTEN THE WHEEL NUT.
Excessive tightening can cause the wheel to
crack during operation.
INSPECT GRINDING WHEEL for visible defect.
Check the wheel for fissures and cracks. Re-
place defective wheels prior to use.
ADJUST distance between wheel and work rest
to maintain 1/16" (1,6 mm). or less separation,
readjustment is necessary as the diameter of
the wheel decreases with use.
ALWAYS EASE THE WORKPIECE AGAINST THE
ABRASIVE WHEEL when starting to grind. A
hard impact can break the wheel. Use light
pressure when starting to grind; too much
pressure on a cold wheel can cause the wheel
to crack.

FEATURES

KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
3
4
1. ON/OFF SWITCH
Your Bench Grinder features a front access On /
Off switch for convenience and safety.
U se r's m a n ua l
2
1
11